BCT TOP-UP LIST

整體學分承認 – 尚須選修科目表

Programme 課程	Bachelor of Science in Engineering Mechanics, Materials and Design 工程力學、物料及設計學理學士
Precedent Code 尚須選修科目表編號	EMMD-19
Maximum number of credits exempted 最高學分豁免	70
Top-Up Courses 尚須選修科目	(a) Obtain 20 credits from courses labelled D2; (b) Obtain 10 credits from either PHYS S271 or MECH S235; (c) Complete MECH S264/DESN S217; (d) Complete MECH S213 OR MECH S250 + either MECH S254 or MECH S255. (See list of courses at BCT Course Table EMMD-Appendix 1) Notes: (1) Courses form excluded combinations with other courses. Only one of the courses in an excluded combination can count towards a single OUHK award. Students should refer to the list of excluded combinations at http://www.ouhk.edu.hk/excluded_combination for the list of courses that form excluded combinations. (2) Successful completion of MECH S264 is considered as completion of DESN S217. (3) The programme of Bachelor of Science in Engineering Mechanics, Materials and Design and Bachelor of Science with Honours in Engineering Mechanics, Materials and Design will be phased out starting from April 2015. The University will continue to confer the award of the degree of Bachelor of Science in Engineering Mechanics, Materials and Design and Bachelor of Science with Honours in Engineering Mechanics, Materials and Design up to June 2020. ************************************************ (a) 選修 D2 類別的科目，取得 20 學分； (b) 選修 PHYS S271 或 MECH S235，取得 10 學分； (c) 修畢 MECH S264/DESN S217； (d) 修畢 MECH S213 或 MECH S250 及 MECH S254 或 MECH S255兩科其中之一科。 (可供修讀的科目見整體學分承認科目表 EMMD-Appendix 1) 備註： (1) 兩個或多個科目可以構成不可兼修的科目組合。同一組合內的科目不得同時計算入一項學術資格所需的總學分之內。同學需到以下網頁http://www.ouhk.edu.hk/excluded_combination閱覽最新的不可兼修的科目組合表。 (2) 已修畢 MECH S264 的學生，會視同已修畢 DESN S217。 (3) 工程力學、物料及設計學理學士及工程力學、物料及設計學榮譽理學士課程將於二○一五年四月起停辦。本校於二○二○年六月前仍繼續頒授工程力學、物料及設計學理學士及工程力學、物料及設計學榮譽理學士學位。
No. of Top-up Credits required to complete 需修讀的尚須選修學分	50

Revised 01/18 (sixth revision)